Binatone ACTION 950 - Manual (Page 6)

Binatone Help Line - 0845 345 9677
Channel scan searches for active signals in an
for all 8 channels, 38 CTCSS codes or
3.8 Activating the Auto Channel Scan
a. Press the MENU button 5 times, the “SCAN” icon
will display on the LCD Screen.
b. Press the UP or DOWN button to begin scanning
channels.When an active signal is detected, channel
scan pauses on the active channel.
c. Or Press the MENU button six times, the CTCSS flashes
UP or DOWN button to begin
scanning the CTCSS from 1-38.
d. Or press the MENU button seven times, the DCS flashes
UP DOWN
e. P ress the PTT button to stop the scan.
You can send a Call-ring tone to other PMR users to give an
alert that you want to communicate with them.
Press the CALL button
You will hear a ring tone for about two seconds; the“TX”
icon appears on the LCD Screen. Any other units within
the transmitting range and tuned to the same channel
and sub-channel (if applicable) will hear the Call-ring tone.
4.1 Selecting a Call-Ring tone
The Action 950 is equipped with 15 different types of
a. Press the MENU button 8 times, until "C" is displayed with "01"
b. Press the UP or DOWN button to select the desired
Call-ring tone. The Call- Ring tone sound will be
played when changing from one tone to another.
c. Press the PTT button to confirm your setting.
4.2 Activating the Vibrator mode
a. MENU
b. P ress the UP or b utton to set "1" (ring tone only),
c. Press the PTT button to confirm your setting.
The Roger Beep is a tone which is automatically transmitted
whenever the PTT button is released. This alerts the receiving
party to inform that you have intentionally ended the
transmission, and you are now in receive mode.
4.3 Setting the Roger Beep
a. Press the MENU button 10 times, the “ON” icon flashes
on the LCD Screen.
b. Press the UP or DOWN button to select the Roger beep
On/Off.
c. Press the PTT button to confirm your setting.
endless loop
83 DCS codes.
4. Call-Ring tone
Call-Ring tones that you can send to alert other PMR users.
on the LCD screen. Press the
on the LCD screen. Press the
to begin scanning DCS code 1-83.
or button
Note: Your Action 950 can alert you to an incoming signal by emitting
an audible tone and/or a vibration signal.
flashing on the LCD Screen.
different icons on the bottom line, flash on the LCD screen.
Press the b utton 9 times, until "1","2" or "3", with
"2" (ring tone + vibrate) or "3" (vibrate only).
DOWN