Blaupunkt FREIBURG RCR 127 User Manual

Page 13

ENGLISH

DEUTSCH

FRANÇAIS

ITALIANO

NEDERLANDS

SVENSKA

ESPAÑOL

PORTUGUÊS

Notice:
Should you tune in a station which has al-
ready been stored before, then the corre-
sponding preset position and memory bank
will briefly flash in the display.

Automatically storing the
strongest stations with Travel-
store

You can automatically store the six most
powerful FM stations of your current recep-
tion area sorted according to their signal
strength. This function is particularly conven-
ient on longer trips.
•

Press the FMT or BND button for
1 sec.

“T-STORE” will appear in the display.

The six strongest FM stations will be auto-
matically stored on the memory bank “T”
(Travelstore). When this process has been
completed, the radio will play the first sta-
tion stored on preset 1.
If desired, stations can also be stored man-
ually on the Travelstore bank (see “Storing
stations”).

Changing the memory bank

You can shift between the memory banks I,
II and T in order to store stations and recall
them later.
The currently selected memory bank is in-
dicated in the display.
•

Press the FMT or BND button as many
times until the desired memory bank
lights up in the display.

Storing stations

On FM, you can store six stations on the
preset buttons 1-6 for each of the memory
banks I, II and T.
On MW/LW, you can also store six stations
each.

(only with Montreux RCR 127)

•

Select the desired memory bank.

•

Tune in a station with the rocker switch
(either automatically or manually).

•

Press and hold down the desired pre-
set button until the radio resumes play
after the muting (takes approximately 1
sec., confirmed by beep).

Now the station has been stored.

The activated preset button is indicated in
the display.

Recalling stored stations

You can recall any stored station at the touch
of a button.
•

Select the memory bank with FMT or
BND.

•

Press the corresponding preset button
briefly to recall the station.

Scanning stored stations with
Preset Scan

You can have all of the stored stations briefly
scanned on all wavebands.

To start Preset Scan:
•

Press SC for approximately 1 sec.

All of the stored stations to be received will
be scanned one after the other.

To select a scanned station and switch
off Preset Scan:
•

Press SC briefly.

Note:
If “TA” shows on the display panel, the sys-
tem will scan the stored traffic stations only.

Fr/Mont/ColoRCR127 gb®

16.05.2002, 12:59 Uhr