Behringer TUBE CONDENSER MICROPHONE T-47 - Manual (Page 4)

4 TUBE CONDENSER MICROPHONE T-47 User Manual
2. Control elements and connections
2.1 Microphone
You can tell that the T-47 is switched on when the small window glows red.
There is an XLR connector on the bottom end of the microphone. Connect it to
the power supply (PSU-T).
2.2 Power supply
The included BEHRINGER PSU-T not only provides the supply voltage for the
tube preamplifier but also employs a circuit that reduces the low frequency
response. This is activated on the front panel with the LOW CUT switch.
The POWER switch on the unit's rear panel turns on the power supply.
Here you also find the following:
• a seven-pin XLR connector to connect to the T-47 (MIC),
• a three-pin XLR connector to transmit the signal (OUTPUT),
• a switch to suppress signal humming noise (GND LIFT),
• an IEC power receptacle
• and a fuse holder.
◊
Use the provided cable to connect the T‑47 to the power supply unit!