Philips SENSEO® Twist Kaffeepadmaschine - Manual (Page 10)

10
9
Press the selection button to select the
desired coffee strength. Select the cup symbol
with three bars for a regular cup of coffee
(125ml) (1). Select the cup symbol with one
bar for a strong cup of coffee (60ml) (2).
10
When you have selected the desired coffee
strength, press the 1-cup button q for one
cup (1) or press the 2-cup button qq for
two cups (2).
11
When the water has heated up and the on/
off button lights up continuously, the machine
starts brewing coffee.
E Tip:
You can interrupt the brewing cycle at any
time. To do this, press the same cup button (1-
cup button or 2-cup button) that you pressed
to start brewing coffee. However, if you do
this, the machine does not complete the
interrupted brewing cycle if you switch it on
again or press the same cup button again.
D Note:
Do not remove the water reservoir during a
brewing cycle.
D Note:
Make sure the coffee in the pod or pods is
evenly distributed.
C Caution:
Never put normal ground coffee or use torn
pods in the SENSEO ® machine, as this causes
it to become blocked.
7
Close the lid (1) and lock the lever (2).
B Warning:
Make sure the lid is closed properly and
the lid lever is locked before you start
brewing coffee.
8
Place one cup or two cups under the
spout openings. You can adjust the height
of the coffee spout by sliding it upwards or
downwards. You can also remove the drip tray
to be able to place higher cups.
D Note
The cups you use should have a capacity of at
least 150ml when you brew regular coffee or
100ml when you brew strong coffee. Do not
use cups that are too large, as they cause the
coffee to get cold more quickly.