Philips Azur Performer Dampfbügeleisen - Manual (Page 8)

6 Plug in the iron and let the iron heat up to dry the soleplate.
7 Unplug the iron when the temperature indicator light goes out.
8 Move the iron gently over a piece of cloth to remove any water
stains on the soleplate.
Storage
1 Unplug the iron and empty the water tank. Let it cool down in a safe
place.
2 Wind the mains cord around the backplate of the iron and store it
on its heel.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Centre in your
country (see the worldwide guarantee leaflet for contact details).
Problem Possible cause Solution
The steam boost function
does not work properly
(water leaks out of the
soleplate).
You have used the steam boost
function too often within a very
short period.
Wait for a few seconds before you
use the steam boost function again.
You have used the steam
boost function at a too low
temperature.
Set an ironing temperature at which
the steam boost function can be used
(●●● to MAX).
Flakes and impurities come
out of the soleplate during
ironing.
Scales are formed inside the
soleplate.
Use the Calc-clean funtion (see
chaper ‘Cleaning and maintenance’,
section ‘Calc-clean function’).
Water leaks from the water
filling door.
You have overfilled the water
tank.
Do not fill the water tank beyond the
MAX indication. Pour excess water
out of the water tank.
ENGLISH
10