Bissell ProHeat 2X 9500-P User Manual

Guide, Quick start, Warning

BISSELL is happy to be of service.

visit the website for helpful instructions at

www.bissell.com

Quick Start

Guide

PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE

PLEASE KEEP FOR FUTURE REFERENCE

BISSELL Homecare, Inc.
P.O. Box 1888
Grand Rapids, MI 49501

Phillips head screw driver is needed for assembly

Package contents:

Model 9500-P

a. Machine Base & 2 tank system
b. Upper Handle
c. 4 Screws - taped to handle
d. Upper Hose Rack
e. Lower Hose Rack

f. Formula
g. TurboBrush® Tool
h. 2-in-1 Crevice Tool
i. 6-Inch Stair Tool

Carpet cleaning

Bare Floor cleaning

Cleaning with attachments

1. While pressing the trigger, make one slow forward

wet pass and another one back

2. Release the trigger and make one slow forward

and backward pass over the same area. Repeated

passes will help aid in dry time

3. Continue passes until cleaning area is complete
4. When the dirty water reaches the “FULL” line on the tank,

it is time to empty

5. Empty dirty water by removing tank from base of machine.

Carry to sink or outside to dispose of water. Unlatch top of

tank and pour dirty water through triangle shaped opening in corner

6. Refill as needed, following steps 4 & 5 under "Before you begin cleaning"

1. Fill the formula tank to "WATER" line with water. Fill to

"FORMULA" line with BISSELL 2X Hard Floor Solutions.

2. Attach the bare floor tool onto the bottom of the

machine by hooking it into the nozzle and swinging

it down until it clicks into place.

3. Slowly move the machine forward and back over hard floor surface one

time while depressing trigger. Caution: Do not overwet.

4. Repeat the motion without pressing the trigger to suction up the dirty water.
5. When the dirty water reaches the “FULL” line on the tank, follow instruction

#5 under “Carpet Cleaning” to empty tank

6. When cleaning is complete, remove and rinse tool in warm water
7. Allow adequate time for floors to dry.

1. Set ReadyTools dial to the “TOOLS” setting
2. Attach the cleaning tool to the end of the hose
3. Clean by pressing the trigger to spray solution

onto the area to be cleaned

4. Slowly scrub the tool back and forth over the soiled surface
5. Tilt the tool forward to suction liquid
6. Follow steps 5 & 6 under "Bare Floor cleaning"

WARNING:

Refer to the enclosed user guide for complete

instructions and important safety notices.

Refer to the User’s Guide for full instructions on how to clean, store and maintain your machine

For additional tips and troubleshooting
Please refer to User's Guide

Visit: www.bissell.com

120-4493