Beko WME 7267 W - Manual (Page 20)

EN 20
Auxiliary functions
Auxiliary function selection keys
• Depending on the programme,
you can select the desired auxiliary
function by pressing the buttons.
• Select the required auxiliary
functions before starting the
programme.
• Some combinations cannot be
selected together. (Ex.: Prewash
and Quick Wash.
• Symbol of the selected auxiliary
function (Figure 2-2l) will light up.
Auxiliary function selection
If an auxiliary function that should not
be selected together with a previously
selected function is chosen, the first
selected function will be cancelled and
the last auxiliary function selection will
remain active.
(Ex.: If you want to select prewash first
and then quick wash, prewash will be
cancelled and quick wash will remain
active.
Auxiliary function that is not compatible
with the programme cannot be selected.
(see, “Programme Selection Table”)
• Prewash
When you select this function, the
display will indicate “F1” symbol.
• A prewash is only required with
heavily soiled laundry. Without
prewash you save energy, water,
detergent and time.
• Prewash without detergent is
recommended for veils and curtains.
• Quick Wash
With this programme, the wash time is
shortened. “F2” symbol will light up on
the display.
• Use this function for smaller
amounts or slightly soiled laundries.
• Extra Rinse
This function allows your machine to
perform an extra rinsing in addition to
the rinsing cycles performed by your
machine after main washing cycle.
Thus, the risk for sensitive skins (babies,
allergic skins and etc.) to be effected by
the minimal detergent remnants on the
laundry is reduced. “F3” symbol will light
up on the display.
• Anti- Crease
With this function, boiler movement will
be lessened to prevent creasing and
spinning speed is limited. In addition,
washing is carried out at a higher water
level. “F4” symbol will light up on the
display.
• Use this function for delicate
laundries that crease easily.
C Whenever you select this auxiliary
function, load your machine with
half of the maximum laundry amount
specified in the programme table.
Time screen
The display shows the time remaining
for the programme to complete while a
programme is running. Time is displayed
in hours and minutes as “01:30”.
Time delay
With the “Time delay” function you can
delay the programme start up to 24
hours. Setting can be made in intervals
of 30 minutes.
1. Open the loading door, place the
laundry inside and fill with detergent.
2. Set the washing programme,
temperature, spin speed and,
11a 11b 11c 11d