Vitek VT-1374 - Manual (Page 5)

5
Washable rechargeable shaver
with LCD display
Parts list
1. Protective cap
2. Shaving block
3. Rotating blades
4. Blade drive
5. Shaving block locking button
6. Shaver body
7. Power switch with blocking button
8. LCD display
9. Charger
10. Cleaning brush
11. Travel bag
Charging (Pic.1)
Before first using the shaver or after
long periods of disuse, the batteries
must be charged for 6 hours.
- Connect the charger plug (9) to the
jack on the bottom of the shaver
body and connect the charger to AC
power, the display (8) will show the
necessary information.
- Consequent charging cycles should
not exceed two hours.
Attention!
- Do not charge the batteries for
more than 10 hours and in tempera-
tures less than 0°Ñ or more than
40°Ñ as this can lead to a reduction
in charge capacity.
- If you don't use the shaver for more
than 20 days, charge it for four
hours.
Using the shaver
The best shaving results are achieved
if your skin is dry.
Your skin may need 2-3 weeks to adapt
to this shaving system.
- Remove the protective cap (1).
- Turn on the switch (7).
- Lightly touch the skin, moving
around the shaving block using
simultaneous up-down and rotating
motions.
- Turn off the shaver with the power
switch (7), cover the shaving block
with the protective cap (1) and store
the shaver.
Using the trimmer (Pic. 2, 3)
The trimmer is designed for evening
whiskers and caring for mustaches.
- Move the trimmer switch to the
upper position.
- Turn on the shaver with the switch
(7).
- Position the shaver at the correct
angle to the skin and move it gradu-
ally down, evening the whiskers.
- Turn off the shaver and move the
trimmer switch to the lower posi-
tion.
Cleaning the shaver
- Press the shaving block locking but-
ton (5) to open the shaving block and
gain access for cleaning (Pic. 4).
- Using the brush (10), clean the
shaving block inside and out, and
also the blade drive (Pic. 4).
- The shaving block can be washed
under a stream of warm water (Pic.
5). Dry the shaving block complete-
ly before closing. Do not allow water
into the electric shaver's body. After
completely dry, close the shaving
block, reinstall the protective cap
(1) and put away for storage.
ENGLISH
Vt-1374.qxd 24.01.05 12:47 Page 5