Philips PerfectCare Azur Dampfbügeleisen - Manual (Page 13)

Problem Possible cause Solution
The iron does not
produce any steam.
There is not enough water in
the water tank.
Fill the water tank (see chapter ‘Preparing
for use’, section ‘Filling the water tank’.
The steam slider is set to ‘no
steam’.
Set the steam slider to MAX (see chapter
‘Preparing for use’, section ‘Steam settings’).
The iron is not hot enough yet
to produce steam.
Wait until the SmartLight has stopped
flashing and lights up steadily.
The iron does not
produce a steam boost.
You have used the steam boost
function too often within a very
short period.
Continue ironing in horizontal position
and wait a while before you use the steam
boost function again.
The iron is not hot enough yet
to produce a steam boost.
Wait until the SmartLight has stopped
flashing and lights up steadily.
Water droplets drip
onto the fabric during
ironing.
You have not closed the water
tank lid properly.
Press the lid until you hear a click.
You are ironing while the
SmartLight is blinking.
Wait until the SmartLight lights up steadily
before ironing.
You have put a chemical into the
water tank.
Rinse the water tank and do not put any
perfume or chemical into the water tank.
The iron leaves a shine
or an imprint on the
garment.
The surface to be ironed was
uneven, for instance because
you ironed over a seam or a
fold in the garment.
The iron is safe to use on all ironable
garments. The shine or imprint is not
permanent and disappears when you wash
the garment. Avoid ironing over seams or
folds. You can also place a cotton cloth over
the area to be ironed to avoid imprints.
EnGlish 13