Dimensions & specifications, Male flare fitting – Bunn CDBCF TWIN APS User Manual
Page 2
BUNN
®
practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
All dimensions shown in inches.
Bunn-O-Matic Corporation owns all copyrights relating to materials in this publication. Please contact BUNN to request permission to reproduce any portion of this publication.
Dimensions & Specifications
Bunn-O-Matic
®
Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax 217-529-6644 • www.bunn.com
Model
Product #
Volts Amps Tank Heater Total
Brewing
Cu.
Shipping
Cord
Watts
Watts
Capacity
Ft.
Weight
Attached
CDBCF Twin APS 29600.0001 120/240
26
2 @ 3000
6100
15 gal./hr.
7.3
64 lbs.
No
Brewing capacity: based upon incoming water temp of 60ºF (140ºF rise) per
1
/
2
gallon brew time of 4 minutes.
Models listed as 120/208V or 120/240V must be connected to 208V or 240V electrical service respectively. Please refer to the installation manual.
Electrical: 3-wires plus ground service rated 120/240V, single phase, 60Hz.
Plumbing: 20-90 psi (138-621 kPa). Machine supplied with
3
⁄
8
” male flare fitting.
����
����
���
����
����
���
����
���
����
��
��
���
��
����
������������
����������
�������������
����������
����������������������
���������������
����
����
��������
���������