Philips Dampfbügelstation - Manual (Page 9)

Problem Possible cause Solution
Water droplets
come out of the
soleplate.
After the Calc-Clean process,
remaining water may drip out
of the soleplate.
Wipe the soleplate dry with a piece of
cloth. If the Calc-Clean light still flashes and
the appliance still beeps, perform the
Calc-Clean process (see chapter
‘IMPORTANT - Cleaning and
maintenance’).
The Calc-Clean process has
not been completed.
You have to perform the Calc-Clean
process again (see chapter ‘IMPORTANT
- Cleaning and maintenance’).
Dirty water and
impurities come
out of the
soleplate.
Impurities or chemicals present
in the water have deposited in
the steam vents and/or
soleplate.
Perform the Calc-Clean process regularly
(see chapter ‘IMPORTANT - Cleaning and
maintenance’).
Water flushes out
of the soleplate.
You have accidentally started
the Calc-Clean process
(see chapter ‘IMPORTANT -
Cleaning and maintenance’).
Switch off the appliance. Then switch it
back on again. Turn the temperature dial to
the desired temperature setting instead of
CÁLC CLEAN. Let the iron heat up until
the ‘iron ready’ light lights up steadily.
The Calc-Clean
process does not
start.
You have not set the
temperature dial to CALC
CLEAN or you have not
waited for the iron to heat up.
See chapter ‘IMPORTANT - Cleaning and
maintenance’.
You have not pressed the
Calc-Clean button for
2 seconds until the appliance
started beeping.
See chapter ‘IMPORTANT - Cleaning and
maintenance’.
ENGLISH 9