Warning – Baby Trend Sit n Stand Plus 11.07 User Manual

Page 5

1. The rear platform and jump seat are designed to accommodate a child

who is at least 2 1/2 years old, has good balance and coordination, and is

not over 40 inches tall. Position the child on the platform on the back of

the stroller. Be sure child is facing forward and hands are holding frame.

Secure the safety belt behind child and engage buckle. Fig. 12.

2. Be sure that the child’s feet are fully on the platform at all times.

PLEASE NOTE: When using the rear SEAT you must put the STAND

FEATURE SAFETY BELT in the storage location located on the rear of

the seat. Please See Fig. 12A

WARNING:

To avoid a possible

choking hazzard when using the rear seat, put

the STAND FEATURE SAFETY BELT in the

storage location on the rear of the seat.

TO SECURE REAR STANDING CHILD

Fig. 11.

Fig. 12.

Shoulder Strap

Squeeze

Crotch Strap

Waist

Strap

Adjust for a

snug fit

Fig. 10.

STEP ONE: REMOVING THE REAR SEAT

1. Remove the rear canopy by sliding the square fittings upward until they

disconnect from the frame.

2. Remove the rear seat from the frame by un-buttoning the upper and lower

seat back fabric from the frame (Fig. 13 & 14) and un-snaping both front

connection points. Fig. 15

3. Detach the (2) shoulder straps from the frame by folding and sliding the

strap through the “D-ring” located on the end of each strap. Fig. 16.

4. Detach the center crotch strap from the frame by folding and sliding the

strap through the “D-ring” located on the end of the strap. Fig. 17.

TO USE JUMP SEAT

Fig. 12A.

Fig. 12B.

Upper

Lower

Snap point

Fig. 13

Fig. 14

This manual is related to the following products: