Philips Azur Dampfbügeleisen - Manual (Page 9)

Note: Do not use the Ionic DeepSteam function when you iron without steam and/or at low temperature
settings. However, ironing at low temperatures without steam with the Ionic DeepSteam function
switched on will not damage the iron.
Note: The Ionic DeepSteam output may vary from time to time, depending on the ironing temperature.
Features
Spray function
You can use the spray function to moisten the article to be ironed. This helps remove stubborn
creases.
1 Make sure that there is enough water in the water tank.
2 Press the spray button several times to moisten the article to be ironed (Fig. 13).
Steam boost function
A steam boost from the special Steam Tip soleplate helps remove stubborn creases. The steam
boost enhances the distribution of steam into every part of the article to be ironed.
The steam boost function can only be used at temperature settings between 3 and MAX.
1 Make sure that there is enough water in the water tank.
2 Press and release the steam boost button (Fig. 14).
- You can also use the steam boost function when you hold the iron in vertical position. This is
useful for removing creases from hanging clothes, curtains etc. (Fig. 15)
Drip stop
This iron is equipped with a drip-stop function: the iron automatically stops producing steam when
the temperature is too low, to prevent water from dripping out of the soleplate. When this happens,
you may hear a sound.
automatic shut-off function
The automatic shut-off function automatically switches off the iron if it has not been moved for a
while.
- Specific types only: The tank light flashes to indicate that the iron has been switched off by the
automatic shut-off function (Fig. 16).
- Sspecific types only: The red auto-off light flashes to indicate that the iron has been switched off
by the automatic shut-off function.
- To let the iron heat up again, pick up the iron or move it slightly. The tank light (specific types
only) or auto-off light (specific types only) stops flashing.
Cleaning and maintenance
Remove the mains plug from the wall socket, set the steam control to position 0 and let the iron
cool down before you clean it.
Do not put vinegar or other descaling agents in the water tank.
after ironing
1 Wipe flakes and any other deposits off the soleplate with a damp cloth and a non-abrasive
(liquid) cleaning agent.
To keep the soleplate smooth, avoid hard contact with metal objects. Never use a scouring pad,
vinegar or other chemicals to clean the soleplate.
2 Clean the upper part of the iron with a damp cloth.
EnGlISh 9