Philips PerfectCare Pure Dampfbügelstation - Manual (Page 7)

Caution: Do not use tap water, perfumed water, boiled water, water
from a tumble dryer, rainwater, vinegar, mineral water, magnetically
treated water (Aqua+), water from a drinking water filter, starch,
descaling agents, ironing aids, salt or chemicals in the water tank.
These types of water have been tested. They are not suitable and may
even cause damage to the appliance. If you use any of these types of
water, your guarantee becomes invalid.
Using the appliance
OptimalTemp technology
Do not iron non-ironable fabrics.
This appliance is equipped with OptimalTemp technology, which enables
you to iron all types of ironable fabrics without adjusting the iron
temperature or steam setting.
- Fabrics with these symbols are ironable, for example linen, cotton,
polyester, silk, wool, viscose and rayon.
- Fabrics with this symbol are not ironable. These fabrics include synthetic
fabrics such as Spandex or elastane, Spandex-mixed fabrics and
polyolefins (e.g. polypropylene), but also prints on garments.
Ironing
1 Place the steam generator on a stable and even surface.
2 Make sure that there is enough water in the water tank (see section
‘Filling the water tank’ in chapter ‘Preparing for use’).
3 Plug in the appliance and press the on/off button. Wait for approx.
2 minutes until the ‘iron ready’ light stops flashing.
4 Press and hold the steam trigger to start ironing. Keep the steam
trigger pressed continuously when you move the iron over the fabric.
Note: The pump is activated each time you press the steam trigger. It produces
subtle rattling sound, which is normal. When there is no water in the water
tank, the pump sound is louder. Fill up the water tank with water when the
water level drops below the minimum level.
ENGlISh 7