Bissell 87R4 - Manual (Page 6)

Cleaning the filter and screen continued
5. Separate filter assembly by grasping tabs on
both sides of assembly and pull. For best results,
periodically tap filter and screen against trash
can to remove dirt that has collected.
6. Reconnect filter and screen by aligning
rectangular tab on filter with insert on screen.
Press together to ensure assembly is secure.
7. See page 5 to reattach dirt container.
NOTE: The dirt container and screen may be
rinsed with cold water. Ensure both are dry before
reinserting. DO NOT RINSE PLEATED FILTER.
Storage/Cord wrap system
A wrap is attached to the cord for quick and
easy storage.
1. To store the unit, turn hand vacuum OFF.
2. Unplug hand vacuum from electrical outlet.
3. Bundle cord, using wrap that is located on
cord, to store.
Nozzle Maintenance
Keep nozzles clean and free of debris.
1. Wipe nozzles clean with damp cloth.
M
aintenance and care
6
w w w . b i s s e l l . c o m
T
roubleshooting
Other maintenance or service not included in the manual should be performed by an
authorized service representative.
Please do not return this product to the store.
Hand vacuum won’t run
Possible causes Remedies
1. Power cord not plugged in 1. Check electrical plug
2. Thermal protector is activated 2. Turn OFF and unplug the unit. Empty dirt
container, clean filter and screen, and clear
any clogs. Wait 30 minutes before turning
the unit back on
Hand Vacuum won’t pick up or low suction
Possible causes Remedies
1. Dirt container not installed properly 1. Check assembly of dirt container making
sure it is snapped in
2. Dirt container is full 2. Empty dirt container and reattach
3. Filter or screen is dirty 3. See instructions above. Replace filter if needed
4. Nozzles are clogged with debris 4. Wipe tools clean with damp cloth
5. 5a.
6.
Insert Tab
ug110-4076_87R4E_1008.indd 6 ug110-4076_87R4E_1008.indd 6 12/10/08 3:31:19 PM 12/10/08 3:31:19 PM