Beko BK 7671 LD PLUS - Manual (Page 9)

Instructions for use
GB
4
Temperature control
and adjustment
Operating temperatures are controlled by the
thermostat knob (Fig. 2) and may be set
between 1 and 5, the coldest position.
When the appliance is switched on for the first
time, the thermostat should be adjusted so that,
after 24 hours, the average fridge temperature
is no higher than +5°C (+41°F ).
We recommend setting the thermostat half-way
between the 1 and 5 setting and monitoring to
obtain the desired temperature i. e. towards 5
you will obtain a lower temperature and vice
versa. Some sections of the fridge may be
cooler or warmer ( such as the salad crisper
and the top part of the cabinet ) which is quite
normal.
In ambient temperatures above 25°C (77°F),
especially in summer, turn the thermostat knob
towards 5. In ambient temperatures below
25°C (77°F) turn the thermostat knob to a half
way position.
Frequent door opening causes internal
temperatures to rise, so it is advisable to close
as soon as possible after use.
Before operating
Final Check
Before you start using the appliance check that:
1.
The feet have been adjusted for perfect
levelling.
2.
The interior is dry and air can circulate freely
at the rear.
3.
The interior is clean as recommended under
"Cleaning and care.”
4.
The plug has been inserted into the wall
socket and the electricity is switched on. When
the door is open the interior light will come on.
And note that:
5.
You will hear a noise as the compressor
starts up. The liquid and gases sealed within
the refrigeration system may also make some
(noise), whether the compressor is running or
not. This is quite normal.
6.
We recommend setting the thermostat knob
midway and monitor the temperature to ensure
the appliance maintains desired storage
temperatures (See section Temperature Control
and Adjustment).
7.
Do not load the appliance immediately it is
switched on. Wait until the correct storage
temperature has been reached. We recommend
checking the temperature with an accurate
thermometer (see; Temperature Control and
Adjustment).