Bushnell Trophy Cam 119445 - Manual (Page 26)

26
Camera won’t power up
1. Make sure that you have installed at least 4 batteries (the
required minimum #) in the battery compartment, starting at the
top, filling battery spaces 1-4 with no “gaps”.
Bushnell recommends using 8 Energizer
®
Lithium AA batteries
in all Trophy Cams.
2. Make sure that the batteries are installed correctly, observing
proper polarity. Always place the negative (flat) end of each
battery in contact with the spring side of its slot inside the
camera.
3. After moving the switch from “Off” to “Setup” or “On”, make
sure that the switch is correctly in position to ensure the proper
mode (avoid positions “between” two modes).
4. Do not move the switch directly from “On” to “Setup”-always
move the switch all the way down to “Off” first, then back up
to “Setup”.
Still Photo and/or Video Quality Problems
1. Night photos or videos appear too dark
a. Check the battery indicator icon to see if battery power is
full. The flash will stop operating near the end of the battery life.
b. You will get the best results when the subject is within the
ideal flash range, no farther than 45’ (14m) from the camera.
Subjects may appear too dark at greater distances.
c. Please note that when the Capture Number parameter is
set higher than “1 Photo”, or with very short Interval settings,
some images may appear darker than others due to the quick
response and rapid retriggering of the camera, allowing less
time for the flash to fully recharge before firing again.
2. Daytime photos or videos appear too dark
a. Make sure that the camera is not aimed at the sun or other
light sources during the day, as this may cause the auto exposure
to produce darker results.
3. Night photos or videos appear too bright