BT DECOR 200 - Manual (Page 3)

Installing
your Decor
200
Situate your Decor 200
close enough to a phone
socket so that the cables
will reach.
Do not stand it on carpets
or other similar surfaces
that generate fibres.
Do not cover or enclose
the machine; allow a free
flow of air to its surfaces.
Your Decor 200 can be
wall-mounted. See ‘Wall-
mounting’.
If you do not have a
modern style socket, call
Free
fone 0800 800 150
and ask for a BT
engineer to come and fit
the correct socket. This
is a chargeable service.
2
The ringer volume
switch is located on the
underside of your Decor
200 and effects the volume
at which your phone rings.
There are two settings:
HI
A loud ring; your Decor
200 is preset to this
position.
LOW
A quiet ring.
Your Decor 200 is
now ready for use.
Using your
Decor 200
Lift the handset and
listen for a dialling tone.
Display shows:
Dial the number you
require. The display
shows the number dialled.
To end the call, replace
the handset.
When the phone rings
pick up the handset and
speak.
Lift the handset.
Press the REDIAL button.
The phone will
automatically dial the
last number dialled.
Your Decor 200 has three
‘one-touch’ memory
buttons.
You can store a number
on each of these buttons
and dial the number by
pressing just one button;
so there is no need to
dial all the digits every
time.
To store numbers in the
memory you use the
Warning
Your Decor 200 is only
designed to be operated in
a normal office or
domestic environment.
It should not be used in
bathrooms or near water.
HI
LO
Redial
1
2
1
1
2
1 Situating your
Decor 200
2 Check your telephone
wall socket
3 Plug your Decor 200
into the telephone wall
socket
4 Set the ringer
volume
To make a call
To receive a call
To redial the last
number dialled
To store phone
numbers in the ‘one-
touch’ memory
M1 M2 M3