Liebherr CTNes 4753 Premium NoFrost - Manual (Page 6)

14
Interior LED light
An LED lamp is fitted as standard to illuminate
the interior of the appliance.
The light intensity of the LED light cor-
responds to laser class 1/1M.
Important
If the cover is removed, do not look di-
rectly at the light through optical lenses
from close distance. This can damage
your eyes.
Cooling
Storage example
1
butter, cheese
2
eggs, cans, tubes
3
bottles
4
frozen food, ice cubes
5
meat, sausage products, dairy
products
6
baked goods, pre-cooked meals,
drinks
7
fruit, vegetables, salad
Note
• Food which gives off or absorbs
odours and flavours as well as
liquids should always be stored
covered or in closed containers.
High-percentage alcohols should
be tightly sealed and stored upright.
• Fruit, vegetables and salad can be
stored unpacked in the drawers.
Freezing
The maximum amount of food
wich can be frozen in 24 hours is
shown on the type plate ("Freezing
capacity").
SuperFrost
By activating the SuperFrost function the temperature in the freezer
compartment will drop to the lowest attainable value. Thus food
can be rapidly frozen to the core and the quality is preserved.
• Press the SuperFrost button. The SuperFrost lamp comes on.
• Wait 24 hours.
• Place the fresh food in the freezer.
• The SuperFrost facility automatically switches the fast
freezing procedure off after 65 hours.
You should not switch on the SuperFrost function:
- when placing frozen food in the freezer;
- when freezing up to approx. 2 kg fresh food daily.
Cooling with fan
With the fan function switched on, a uniform temperature distribu-
tion will be attained in the refrigerator compartment.
This is recommended:
- in high room temperatures (approx. 33°C or higher),
- if the air humidity is high (e.g. during the summer).
To switch on
Press the fan button - the LED in the button will come on.
Making ice cubes
• Fill the ice cube tray with water.
• Place the ice cube tray in the appliance
and leave it to freeze.
• The ice cubes can be removed from the tray
by twisting or by holding upside down for a short
time under running water.
Replacing the lamp
If the lamp is defective, it can be replaced taking into account the
following points.
1. Pull out the plug or switch off
the fuse.
2. Press the light cover together at
the sides (1), lift out and unclip
at the back (2).
When using an LED lamp
Only original LED lamps from the appliance manufacturer may
be used. The lamp can be purchased from the customer service
department or specialist dealers.
WARNING!
When using LED lamps made by other manu-
facturers, there is a risk of overheating or fire.
When using a normal light bulb
Use a bulb of max. 25 W, bulb fitting: E14.
The voltage specified on the light bulb must
correspond to the voltage given on the type
plate.
The position of the type plate is shown in
the section entitled Description of the
appliance.
3. Unscrew the defective lamp and screw in the new one.
4. Clip the back end of the cover in and clip the sides into place.