Liebherr ZKes 453 Humidor - Manual (Page 6)

22
Switching on for the first time
Before switching on the appliance, fill the water tank
with 1 litre of distilled water.
Use distilled water only!
Fold down the front flap completely and if necessary
slide it into the appliance as far as it will go. Lift the
water tank slightly, remove and fill with water.
Replace the water tank, sliding it in as far as it will go.
Pull out the front flap completely and fold upwards at
a 90° angle.
To switch on
Press the
On/Off button. The display will flash.
The appliance will take 24 hours to reach the correct
level for storing cigars (temperature, humidity).
The factory setting is +18°C and 70% humidity.
To switch off
Press the
On/Off button for 3 seconds until the display goes dark.
Setting the temperature
To reduce the temperature
Press the
Down button.
To increase the temperature
Press the
Up button.
- While you are entering the tempera-
ture, the set temperature will flash on
the display.
- The electronic controls will switch over automatically about 5 seconds after the last
time you pressed the button, and the interior temperature will be displayed. The tem-
perature can be set between +16°C and +20°C.