Liebherr WTb 4212 Vinothek - Manual (Page 6)

14
Interior light
The interior light will always switch on when the appliance door
is opened.
Press the Light button if you want the interior light to be
on even when the door is closed.
Labels
The appliance is supplied with
a label holder with labels for
each shelf. Use these to label
the type of wine stored on
each shelf.
Additional labels can be ob-
tained from your dealer.
Click the label holder into place
and slide the label in from the
side.
Changing the tube
Pull out the mains plug!
1 Pull the left-hand side of the
light cover downwards. There
are notches at the front and
rear for this purpose.
2 Slide the light cover to the
left.
3 Remove the light cover
downwards.
4 Turn the fluorescent tube
through 90° and remove it
downwards.
Fit the new fluorescent tube and turn it through 90°.
Fit the cover and slide it to the right until it engages.
Additional functions
Adjusting the display brightness
Press for 5 seconds. Display =
Display =
Display =
Use buttons and to select the desired setting.
h1 = minimum brightness
h5 = maximum brightness
Display =
Display =
The adjusted brightness will be activated after one minute.
Note
If a button is pressed, the display lights up for one minute at
maximum brightness.
When commissioning the appliance, the adjusted brightness will
only be active once the set interior temperature of the appliance
has been reached.
Demo mode
Demo mode can be activated for presenting the appliance at
exhibitions or in salesrooms as though in normal operating mode.
When in this mode, the cooling circuit is switched off!
If this mode is activated by accident, it can be deactivated as
detailed below.
Press + for 5 seconds.
Display =
Display =
The refrigeration unit switches on.
The temperature display flashes.
The appliance is now in normal operating mode.