Liebherr GGPv 6570 ProfiLine User Manual
Page 6

14
Operating and control elements
1
ON/OFF button (to switch the appliance on and off)
2
Temperature setting buttons
3
Set button (Enter)
4
Audible warning on/off button
5
Display
Symbols in the display
Compressor is running
LED flashing - refrigeration unit switches on after a delay. The
compressor will start automatically after the pressure in the
refrigerant circuit has equalised.
Fan is running
Appliance is defrosting
Alarm function
If
appears in the display, the appliance has a fault. Consult
your nearest customer service point.
Switching the appliance on and off
Connect the appliance to the mains - the display reads OFF.
To switch the appliance on
Press the ON/OFF button for approx. 5 seconds so that
the temperature display lights up.
To switch the appliance off
Keep the ON/OFF button pressed for approx. 3 seconds - the
display reads OFF.
Setting the temperature
• Press button
1 sec. The temperature display flashes.
• To increase the temperature (warmer): press button
.
• To reduce the temperature (colder): press button
.
• Press button
again.
The desired temperature setting is saved.
Audible warning signal
- This sounds when the door has been left open for
longer than 240 seconds. The audible warning device
is switched off by pressing the Alarm button.
- It sounds when the interior gets too warm. The temperature
display will also flash. The audible warning device is switched
off by pressing the Alarm button.
LED on constantly. An error code (E0, E1, LO, HI, EE) will
appear in the display at the same time. Consult your nearest
customer service point.
If too large quantities of warm food are put in the appliance at the
same time or the door is left open for a long time, the temperature
will increase and LED will light up (the display will read HI).
This does not mean that the appliance is faulty.
Check the display again after a few hours. If it is still indicating an
alarm, contact your customer service department.
Defrosting
The refrigerator defrosts automatically. The defrost water drains
into an evaporation tray near the refrigeration unit, where the heat
from the compressor causes it to evaporate.
Activating the defrost function manually
If the door has been left slightly open for a long time, a layer of
ice may form in the interior and on the cooling plate. The defrost
function can then be activated manually.
• Press button
for 5 seconds.
• The LED
will come on.
One the appliance is defrosted, the appliance will switch back to
normal mode automatically.