Liebherr ICBN 3356 Premium BioFresh NoFrost - Manual (Page 12)

u Regularly clean the drain opening to allow the water to flow
away (see 6.3) .
A layer of frost or ice can build up in the freezer compartment
after a long period of operation.
The layer of frost or ice builds up faster if the appliance is
opened often or if the food is warm when placed inside.
However, a thick layer of ice will increase the appliance‘s
energy consumption. You should therefore defrost the appli-
ance regularly.
CAUTION
Risk of injury and damage as a result of hot steam!
u Do not use electric heaters or steam cleaners, naked flames
or defrosting sprays for defrosting.
u Do not remove ice using sharp instruments.
u Switch on SuperFrost one day before defrosting.
w The frozen goods are provided with a “cold reserve”.
u Switch off the appliance.
w The temperature display goes out.
w If the temperature display does not go out, the child lock
function (see 5.1) is active.
u Pull out the power plug or switch off the fuse.
u Place cold storage accumulators on top of the frozen food.
u If possible, put the frozen goods in the freezer drawer,
wrapped in newspaper or a blanket, and store in a cool
place.
u Place a pan with hot, not boiling
water on a middle shelf.
-or-
u Half-fill the two lower drawers with
lukewarm water and put them in the
appliance.
w Defrosting is speeded up.
w Defrost water is collected in the drawers.
u Leave the door of the appliance open while defrosting.
u Remove detached pieces of ice.
u Pay attention that the defrost water does not run into the
kitchen unit.
u If necessary, pick up defrost water several times, using a
sponge or cloth.
u Clean the appliance (see 6.3) and rub dry.
6.3 Cleaning the appliance
WARNING
Risk of injury and damage as a result of hot steam!
Hot steam can lead to burns and can damage the surfaces.
u Do not use any steam cleaners!
NOTICE
Incorrect cleaning damages the appliance!
u Do not use cleaning agents in concentrated form.
u Do not use any scouring or abrasive sponges or steel wool.
u Please do not use any aggressive, scouring, sand-,
chloride-, chemical- or acid-based cleaning agents.
u Do not use chemical solvents.
u Do not damage or remove the type plate on the inside of the
appliance. It is important for the customer service.
u Do not pull off, bend or damage cables or other compo-
nents.
u Do not allow any cleaning water to enter the drain channel,
ventilation grille or electrical parts.
u Please use soft cleaning cloths and a universal pH-neutral
cleaning agent.
u Please use cleaning and care products suitable for contact
with foodstuffs in the appliance interior.
u Empty appliance.
u Pull out the power plug.
u Clean plastic outer and inner surfaces with lukewarm
water and a little washing-up liquid.
u Clean drain hole: Remove deposits
with a narrow instrument, e.g. a
cotton bud.
u Most of the parts can be dismantled for cleaning: see the
relevant chapter.
u The door interior parts are dishwasher-safe. However, the
printing may dissolve over time.
u Clean other items of equipment by hand with lukewarm
water and a little washing-up liquid.
u Only use a damp cloth to clean the telescopic rails. The
grease in the runners is for lubrication purposes and must
not be removed.
After cleaning:
u Wipe dry the appliance and items of equipment.
u Connect the appliance and switch it on again.
u Switch on SuperFrost (see 5.6.4) .
When the temperature is sufficiently cold:
u Put the food back inside.
6.4 Cleaning the IceMaker*
The drawer of the IceMaker has to be emptied and slid in.
u
To activate the setting mode: press the SuperFrost button
Fig. 2 (12) for about 5 s.
w The display indicates c .
w The menu symbol Fig. 2 (16) shines.
u Using the Up setting button, freezer compartment
Fig. 2 (10) / Down setting button, freezer compartment
Fig. 2 (11) select I .
u To confirm: press the SuperFrost button Fig. 2 (12) .
u Using the Up setting button, freezer compartment
Fig. 2 (10) / Down setting button, freezer compart-
ment Fig. 2 (11) select Ic .
u To confirm: press the SuperFrost button
Fig. 2 (12) .
u To deactivate the setting mode: press the On/Off button,
freezer compartment Fig. 2 (8) .
-or-
u Wait for 2 minutes.
w The temperature is indicated again in the temperature
display.
u Remove the drawer.
u Clean the ice cube tray and drawer with warm water. If
necessary, use mild washing-up liquid. Then rinse.
u Slide in the drawer again.
If washing-up liquid was used:
u throw away the first three loads of ice cubes to get rid of any
remaining washing-up liquid.
Either leave the IceMaker switched off in this position or switch
the IceMaker on again (see 5.6.10) .
6.5 Customer service
First check whether you can correct the fault yourself by refer-
ence to the list (see Malfunction). If this is not the case, please
contact the customer service whose address is given in the
enclosed customer service list.
Maintenance
12 * Depending on model and options