Liebherr WKr 3211 Vinothek - Manual (Page 4)

12
Setting the temperature
To increase the temperature
Press the Up button.
To reduce the temperature
Press the Down button.
- When pressing one of the buttons for the first time, the display
will start to flash.
- Pressing this button again enables you to change the temperature
setting.
- The electronic controls will switch over automatically about
5 seconds after the last time you pressed the button, and the
actual temperature will be displayed.
Storing wine
If you are storing wine for long periods of time, it should be stored
at a temperature of between 10°C and 14°C.
This is the temperature wine cellars are kept at, and it is just right
to allow wine to mature properly.
The following drinking temperatures are recommended for the
various types of wine.
Red wines: +14°C to +18°C
Rosé wines: +10°C to +12°C
White wines: +8°C to +12°C
Sparkling wines, Prosecco +7°C to +9°C
Champagne +5°C to +7°C
Operating and control elements
1 Temperature display
2 Temperature setting buttons
3 Audible warning on/off button
4 Child lock activated symbol
5 On/off button
6 Fan button
Switching the appliance on and off
To switch the appliance on
Press the On/Off button until the temperature display
lights up.
To switch the appliance off
Keep the On/Off button pressed for approx. 3 seconds so that
the temperature display goes out.
Setting up
• Avoid positioning the appliance in direct sunlight or near cookers,
radiators and similar sources of heat.
• The floor on which the appliance stands should be horizontal
and level.Compensate for uneven floors with the adjustable feet.
•
Do not cover ventilation openings
or grille.
• Standard EN 378 specifies that the room in
which you install your appliance must have
a volume of 1 m 3 per 8 g of R 600a refriger-
ant used in the appliance, so as to avoid the
formation of inflammable gas/air mixtures in
the room where the appliance is located in
the event of a leak in the refrigerant circuit.
The quantity of refrigerant used in your ap-
pliance is indicated on the type plate on the
inside of the appliance.
• Always install the appliance directly against
the wall.
Dimensions
WKr 1811 A = 890 mm B = 613 mm C = 1172 mm
WKr 3211 A = 1350 mm B = 739 mm C = 1298 mm
WKr 4211 A = 1650 mm B = 739 mm C = 1298 mm
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion
of direct current to alternating/three-phase
current) or energy-saving plugs. Risk of dam-
age to the electronic control system!