Liebherr WTpes 5972 Vinidor - Manual (Page 4)

16
Operating and control elements
The electronic control panel has the new "touch capacitance
technology". Any function can be activated by touching the
corresponding icon.
The exact contact point is
between the symbol and its label
1 Upper compartment temperature display
2 Lower compartment temperature display
3 Upper compartment temperature setting buttons
4 Lower compartment temperature setting buttons
5 On/Off button (switching the appliance on and off)
6 Audible warning On/Off button
7 Fan switch
8 Interior light On/Off button
Symbols in the display
Alarm (symbol flashes if the temperature inside the appli-
ance is too high or too low)
Demo mode is activated
Setup mode is activated (activating the child lock and
adjusting the display brightness
The interior fan runs constantly
Child lock is activated
The interior light is switched on constantly
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion
of direct current to alternating/three-phase
current) or energy-saving plugs. Risk of dam-
age to the electronic control system!
Climate rating
The climate rating indicates the room
temperature at which the appliance may
be operated in order to achieve full refrig-
eration performance.
The climate rating is indicated on the
type plate.
The position of the type plate is shown in the section entitled
Description of the appliance.
Climate rating Room temperature
4 (SN) +10°C to +32°C
4 (N) +16°C to +32°C
4+ (ST) +16°C to +38°C
4+ (SN-ST) +10°C to +38°C
5 (T) +16°C to +43°C
5 (SN-T) +10°C to +43°C
Do not operate the appliance outside the
specified room temperature range.
Setting up
• Avoid positioning the appliance in direct sunlight or near cookers,
radiators and similar sources of heat.
• The floor on which the appliance stands should be horizontal
and level.Compensate for uneven floors with the adjustable feet.
•
Do not cover ventilation openings
or grille.
• Standard EN 378 specifies that the room in which
you install your appliance must have a volume
of 1 m 3 per 8 g of R 600a refrigerant used in
the appliance, so as to avoid the formation of
inflammable gas/air mixtures in the room where
the appliance is located in the event of a leak in
the refrigerant circuit. The quantity of refrigerant
used in your appliance is indicated on the type
plate on the inside of the appliance.
• Always install the appliance directly against the wall.
• Place the appliance in its final position
at the place of installation.
Extend the adjustable foot at the bottom
hinge bracket until it rests on the floor
and then make a further 90° turn.
Dimensions