Bissell 94V5 - Manual (Page 5)

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
A
ssembly
deluxe charging base
the included charging base can be
mounted on the wall or sit on a table top.
Mounting on wall (optional)
1. Select an area close to a wall outlet and
make sure the wall area is free from any
hidden electrical wires, water pipes and
gas lines.
note: do not mount near direct
sunlight, near a heat source or
outdoors.
2 . Select an appropriate drill type for the
material to be drilled.
3.
Carefully measure and mark the location
of the screw holes and then drill holes
and screw the wall mounting base onto
the wall.
charging
***iMPoRtant***
alWays tuRn unit off PRioR to
cHaRging*
*failing to do so may result in battery
not fully charging
1.
In order for the unit to charge, the hand
vac must be securely in the charging
base, with the charging contacts fully
engaged.
2. Plug the charging base adaptor into the
wall outlet. The red indicator light will
illuminate and remain on when plugged
into wall outlet. Charge the unit com-
pletely for 24 hours prior to first use.
note: the adaptor may become
warm during charging – this is normal.
3. When the unit is fully discharged,
approximately 16 hours of charging time
is required for the battery to regain full
capacity.
1.
5
3.