Baracoda BRR-L - Manual (Page 23)

RoadRunners BRR-L Programming guide dec 2006
© Baracoda 2006 23/29
3.15/ Set min or Max length option
The following is a procedure to follow for every barcodes
Read « Start - Set min (Max) length » label
START
Read intermediary label
Corresponding to the next digit of the min (Max) length value to
apply (as on a calculator).
Finished ?
Read « END of config » label
END
NO
YES
Programming procedure for “set min (Max) length” option.
Read intermediary label from the below table
to select the desired symbology to configure