Blaupunkt MP35 - Manual (Page 11)

11
FRANÇAIS
ENGLISH
ESP
AÑOL
PORTUGUÊS
RADIO MODE
To save the setting,
➮
switch the device off and on again
or wait approx. 8 seconds. The ra-
dio starts with the last setting acti-
vated (radio, CD/MP3, CD changer
or AUX).
Selecting the frequency range/
memory
This unit can receive programmes
broadcast over the FM and AM frequen-
cy ranges. There are three memory
banks for the FM range and one for the
AM range. Six stations can be stored in
each memory bank.
Selecting the FM memory bank or
the AM frequency range
respectively
➮ Press the BND•TS button
<
to
switch between the FM memory
banks (FM1, FM2 and FMT) and
the AM frequency range respec-
tively.
Tuning into a station
There are various ways of tuning into a
station.
Automatic seek tuning
➮ Press the or button
8
.
The unit tunes into the next receivable
station.
Setting the sensitivity for station
seek tuning
You can configure the radio to only tune
into stations with a strong reception or
to also tune into those with a weak re-
ception.
➮ Press the MENU button
7
.
➮ Press the or button
8
repeat-
edly until “SENS HI” or “SENS LO”
appears in the display.
“SENS HI” means that the tuner is highly
sensitive. “SENS LO” means it is set to
the lower sensitivity setting.
➮ Set the required sensitivity using
the or buttons
8
.
When you have finished making your
changes,
➮ press the MENU button
7
.
Note:
●
Different seek tuning sensitivities
can be set separately for FM and
AM respectively. To do so, activate
the relevant waveband.
Tuning into stations manually
You can also tune into stations manual-
ly.
➮ Press the or button
8
.
Storing stations
Storing stations manually
➮ Select the required memory bank
(FM1, FM2 or FMT) or the AM fre-
quency range.
➮ Tune into the station.
➮ Press one of the station buttons
1 - 6
;
for longer than 2 seconds
to store the station to that button.