Philips Fer à repasser de voyage - Manual (Page 3)

Problem Possible cause Solution
The iron is not hot
enough and/or the
drip-stop function
has been activated.
Set an ironing
temperature that is
suitable for steam
ironing ( 3). Put
the iron on its heel
and wait until the
temperature-ready
light has gone out
before you start
ironing.
The iron
does not
produce
a steam
boost.
You have used
the steam boost
function too often
within a short
period.
Continue ironing in
horizontal position
and wait a while
before you use
the steam boost
function again.
The iron is not hot
enough.
Set an ironing
temperature at
which the steam
boost function can
be used ( 3).
Put the iron on its
heel and wait until
the temperature-
ready light has gone
out before you use
the steam boost
function.
Water
droplets
drip onto
the fabric
during
ironing.
You have not
closed the cap
of the filling
opening properly.
Press the cap until
you hear a click.
You have used
the steam boost
function at a
temperature
setting below 3.
Set an ironing
temperature that is
suitable for steam
ironing ( 3).
3 4239.000.6418.4