beautypg.com

Bosch GWH 1600 PS User Manual

Page 7

background image

6 720 606 518

Installation instructions

7

3.4

Mounting Heater

Remove cover and inspect.

B Loosen the fixing screw, bottom of the front cover.

B Remove the outer cover by pulling it forwards and

then lifting upwards, see Fig. 6.

B Ensure that the flue terminal is clear.

B After inspection, replace front cover.

Install incandescent particle tray.

B Install incandescent particle tray using screws

provided as shown in Fig. 5.

Fig. 5

Incandescent particle tray illustration

Mounting heater.

The heater must be mounted on a wall using
appropriate anchoring materials. If wall is sheathed with
plasterboard, it is recommended that support board(s),
either 1x4’s or 1/2" (minimum) plywood first be
attached across a pair of studs and then the heater
should be attached to the support boards, see Fig. 7.

B Secure the two included L shaped hooks to wall

studs or support board 13 1/4” apart. (See Fig. 7).

B Hang heater on two L shaped hooks. (See Fig. 8).

Fig. 6

Remove front cover

Fig. 7

Support board

Fig. 8

Secure heater to wall

Warning: before starting installation:

B check that there are no loose parts

inside the appliance

B ensure that gas pipe, gas valve, and

burner have no damage and are
properly fitted.

B Read chapter 2.2 to verify proper gas

type and to check all parts are included
in box.

i

Front cover should be removed in order to
inspect components visually (see
instructions below).

Warning:

B Do not install this appliance on a

carpeted wall.

Incandescent particle tray

Screws