Bacharach Infrared Printer - Manual (Page 10)

Instruction 24-9450 6
Operation IrDA Printer
Set-Up Mode
The printer has been set up at the factory with the following default
parameters:
Baud rate : 9600 bps
Handshaking : DTR
Country : U.S.A.
Print mode : Text (upright)
Paper : Normal paper
Density : 100%
IrDA : IrDA-SIR
If necessary, the default parameters can be changed as follows:
1. With the printer initially switched OFF, press and hold down the SEL
pushbutton, and then switch ON the printer.
2. The printer now goes into its set-up mode as indicated by the red LED
flashing. At this time all of the printer’s current parameter settings are
printed, followed by the first parameter that can be modified.
Note: If no button is pressed within 15 seconds, the set-up
mode is automatically terminated without changing the
original parameters.
3. Baud rate is the first parameter printed. Pressing the FEED button
causes the value of that parameter to change in the sequence shown in
the following table.
SEL Button FEED Button
Baud rate
115200, 57600, 38400, 19200, 9600, 4800, 2400,
1200, 600, 300
Handshaking DTR, X-on/X-off
Country U.S.A., Turkish, Denmark2, Norway, Japan, Spain,
Italy, Sweden, Denmark1, U.K., Germany, France
Print mode Text(upright), Data(inverted)
Paper Normal paper, Reprint paper
Density 50 – 150% in 5% steps
IrDA HP-Ir, IrDA-Sir