Bissell 3130 - Manual (Page 11)

11
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Power cord storage
When you have finished using your Easy Vac,
store the power cord on the cord wrap.
1. Turn off vacuum cleaner and unplug power cord.
2. Loop power cord around cord wraps on back
of cleaner, making certain Quick Release cord
wrap is pointed up towards handle.
3. Clip molded plug to power cord to secure.
clean and replace rotating floor brush
you should check your cleaner’s rotating floor brush
and drive belt regularly for wear or damage. you
should also clean the brush and brush ends by
removing string, hair and carpet fibers. these can
wrap around the brush and hamper its ability to
effectively clean your carpet. also, remove any debris
that has accumulated under the brush cover.
1. Turn off vacuum and unplug from electrical
outlet.
2. Place vacuum upside down with brush roll
facing upwards.
3. Remove five screws as shown with a small
Phillips screwdriver.
4. Lift off brush cover.
5. Grasp floor brush at both ends and lift out.
6. Clean strings, hair and other debris from floor
brush, motor shaft, and drive belt.
7. Check floor brush for worn areas and replace
if needed.
8. Check air passageway for obstructions.
Remove debris from this area.
9. When finished cleaning, reposition floor brush
and drive belt. Then replace the brush cover
and five screws.
M
aintenance and care
WaRnInG:
to reduce the risk of
injury from moving parts
and/or electrical shock,
turn power switch off
and disconnect polarized
plug from electrical outlet
before performing
troubleshooting checks.
9.
8. 5.
4. 3.
Air Passageway
Five Screws