Philips Centrale vapeur sous pression - Manual (Page 8)

C
3 Pour water into the steam tank (max. 1 litre).
Use tap water to fill the tank.
◗ If the tap water in your area is very hard, we advise you to use
50% distilled water and 50% tap water.
Do not put perfume, vinegar, starch, descaling agents, ironing aids or
other chemicals in the steam tank.
4 Screw the cap tightly onto the filling aperture of the steam
tank.
Fast refill
C
1 Keep the appliance plugged into the mains and make sure the
iron is on.Then set the steam tank switch to 'off'.
C
2 Press the steam activator until you no longer hear any steam
escaping from the appliance.
3 Keep the steam activator pressed in and slowly unscrew the
cap of the steam tank by turning it anticlockwise.This will
depressurise the steam tank.
Make sure there is no steam left in the steam tank. Place a piece of
cloth over the cap when unscrewing it.
4 Remove the mains plug from the wall socket.
5 Fill the steam tank as described in section 'Filling the steam
tank' and let the appliance heat up again.
Setting the temperature
Always place the steam tank on a stable, level and horizontal surface
Do not put the steam tank on the soft part of the ironing board.
1 Put the iron on the iron stand.
Do not put the hot iron on the supply hose or the mains cord. Make
sure the cord does not come into contact with the hot soleplate.
C
2 Set the required ironing temperature by turning the
temperature dial to the appropriate position.
Check the laundry care label for the required ironing temperature:
ENGLISH 8