Best KER222 - Manual (Page 6)

- 6 -
DECORATIVE
FLUE
WALL
CAP
ROOF CAP
8” ROUND DUCT
8” ROUND
ELBOW
HOOD
24” TO 30” ABOVE
COOKING SURFACE
B B
M
C
LADLE BAR END BITS
LOWER PART OF
THE HOOD
A
A
INSTALL THE DUCTWORK
NOTE: To reduce the risk of fire, use only
metal ductwork.
1. Decide where the ductwork will run between
the hood and the outside.
2. A straight, short duct run will allow the hood
to perform most efficiently.
3. Long duct runs, elbows, and transitions will
reduce the performance of the hood. Use as
few of them as possible.
4. Install a roof or wall cap. Connect 8" round
metal ductwork to cap and work back to-
wards hood location. Use duct tape to seal
the joints between ductwork sections.
HOW TO ASSEMBLE THE
LADLE BAR
The side ladle bars must be assembled before
installing the hood against the wall.
To assemble the side ladle -bars follow the
instructions below:
1. Take off the two end bits of the ladle bar
slackening screws B. Insert the side ladle
bars where the end bits were and fix them
by means of screws B.
2. Insert the fixing element M into the side ladle
bar and fix it tightening screw C.
3. To fix definitively the M element onto the
hood, it is necessary to have access from
the inside of the hood:
- remove the grease filters
: at the handle,
push the stop inwards and pull the filters
downwards.
- take off the lower part of the hood
unscrewing the two screws A. The lower part
of the hood must not be completely taken
off, but it must be bent slightly until the
screwdriver can have access. Fix element
M to the hood from the inside.
4. Reassemble the lower part of the hood.