BT 325 - Manual (Page 21)

Converse 325 ~ 3rd Edition ~ 17th January ~ 4116
20
Wall-mounting
1 Unplug and remove the telephone
line cord from the socket on the stand.
2 Unclip the line plug from the
telephone base.
3 Unclip the stand from the base of
the telephone and remove the stand.
4 Reconnect the telephone line to the
line socket on the base of the phone.
5
Drill two holes in the wall 60mm
vertically apart using a 8mm drill bit.
6
Insert the wall plugs if necessary,
then insert the screws leaving about
8mm protruding from the wall on
which to hang the phone.
7 Rotate the handset clip 180˚ so that
it protrudes upward. This holds the
handset in place when wall-mounted.
8 Hang the holes on the back of the
phone over the screwheads and
gently pull the phone downward to
make sure it is securely in place.
9 Hang the handset on the handset clip.
If you need to leave the phone whilst on
a call you can hang the handset on the
park at the top right hand corner of the
product.
Wall
Wall plug Screw
60mm
W
ALL
-MOUNTING
Note
Before you wall-mount your Converse
325 check that:
• you are not drilling into any hidden
wiring
• you do not need the facility of the
data port.
LINE DATA
60mm