Blaupunkt TRIER RCR 126 - Manual (Page 15)

28
LEARN KC To “define” a second Key-
Card for use with the set.
Please read the information
under “KeyCard theft-pro-
tection system”.
To quit the DSC programming mode and
store the adjustment:
•
Press DSC.
If the setting remains unchanged within 8
seconds, the system will automatically store
the last adjustment. The display will switch
back to the previous condition.
Overview of the DSC factory
settings
TA VOL : 4
BEEP : 3
LED (Code) : 1
LOUD
: 4
RM : OFF
LOCAL : 1
DIS : 1
Appendix
Care notes
Mechanism/cassette tapes
To avoid possible problems, you should not
use cassette tapes longer than 60 or 90
minutes (C60/C90). Store your tapes in a
cool place away from dirt, dust and tempera-
tures exceeding 50
° Celsius. Allow very cold
tapes to warm up before playing them in
order to avoid uneven tape transport. After
approximately 100 hours of use, dust partic-
les collected on the playback head or roller
may lead to tape run problems and sound
distortions.
Use a head cleaning tape to remove normal
dirt build-up. For tougher cases, use a cotton
swab (Q-Tip) soaked with alcohol. Do not
attempt to clean by inserting a hard object
into the player!
Specifications
Amplifier
Output power:
4 x 20 W RMS power
acc. to DIN 45324
(14,4V),
4 x 30 W max. power
FM waveband
Sensitivity:
1,0 µ V at 26 dB
signal-to-noise ratio
Frequency
response:
35 - 16 000 Hz
Tape player
Frequency
response:
35 - 16 000 Hz
Subject to modifications!
BA Trier RCR 126 gb® 13.05.2002, 11:52 Uhr 28