Bosch DAH93 EN - Manual (Page 3)

PAGE 3
Operation - Using the Controls
Before You Begin Cooking
The blower should be turned on for about 5 minutes before
cooking in order to establish air currents upward through
the hood. Thus when heat, smoke, moisture, grease and
cooking odors are produced, they will be carried outside
instead of drifting into other rooms. Use the low speeds for
normal use and the higher speeds for strong odors or fumes.
A Note about Drafts:
Drafts across the range or cooktop will reduce the
effectiveness of the hood. Such drafts should be prevented
when possible. The best job of ventilation in the kitchen is
done when the only air currents are those created by the
blower itself.
The Controls - DAH94 Models
SPEED: Press the button for the corresponding speed:
1 = Low
2 = Medium
3 = High
OFF: Pressing button once turns ventilator off and resets
control.
LIGHT: Press button once to turn lights on or off.
The Controls - DAH93 Models
LIGHT: Press the lower section of the button to turn
lights on. Press the upper part of the button to turn the
lights off.
SPEED: Press the buttons up or down for the corresponding
speed:
The DAH93 model uses rocker switches to activate the
controls. The switch is on when the lower part of the
button is depressed. The switch is off when the upper part
of the button is depressed.
Light Off Speed
1 2 3
OFF: Pressing button once turns ventilator off and resets
control.
SPEED: The first time the button is pressed, it turns the
fan on. The speed is low. The second time the button is
pressed, the medium speed is activated. The third time
the button is pressed, the speed is high.
•
The lights above this button indicate the current
blower speed. When the blower is on, the
corresponding light is lit.
DELAY OFF: Press to turn fan on high for an additional
10 minutes. If the ventilator is off when the button is
pressed, the ventilator will turn on to the high speed
setting for 10 minutes. At the end of the cycle the venti-
lator will turn off.
If the ventilator is on when the button is pressed, the
ventilator runs for 10 minutes at the current speed then
turns off.
•
During this cycle, the light above the DELAY OFF
button is illuminated.
• To cancel the mode, press SPEED or OFF.
FILTER: The hood is equipped with a clean filter
reminder. After 40 hours of operation, the clean filter
reminder light above this button will light indicationg that
the filters need to be cleaned. When the indicator lights,
clean the filters as described on page 4. After cleaning,
press the FILTER button for 3 seconds to reset.
LIGHT:Press button once to turn lights on.
DIM: With the lights on, press and hold the light
button until desired light level is achieved.
OFF: Press the button twice to turn the
lights off. If the lights are dimmed,
press the button once to turn them off.
Off Speed Delay Off Filter Light
1 2 3 Off
The Controls - DAH95 Models
Speed Light
1 2 3
Off
HEAT SENSOR: The heat sensor notifies you that the
conditions below the hood have exceed allowable limits.
The light above the Speed button will blink. Turn
on the next highest speed. The light will stop blinking
when the temperature has dropped to an allowable level.
If the blower is off when the heat sensor is activated, the
low speed will be automatically activated.
LOW:
MEDIUM:
HIGH:
Speed
1 2 3
Off
Speed
1 2 3
Off
1 2 3
Speed Off