Philips goLITE BLU luz de energía - Manual (Page 14)

late evening (and again a couple of hours later, if you can) each night,
starting 2-3 days before you leave. Use the goLITE BLU energy light 2-3
hours later each successive night. When you arrive at your destination, try
to stay awake until bedtime and avoid bright evening light (wear
sunglasses) for the first few days. Before you travel home, avoid any bright
afternoon and evening light and use your goLITE BLU energy light in the
morning for a few days (see above under ‘Travelling east’).
For more instructions on how to avoid jet lag, visit www.philips.com/golite.
charging
Note: You can also use the appliance while it is charging.
The goLITE BLU energy light comes with a 9.5V AC/DC adapter
that operates on voltages ranging from 100 to 240 volts to allow
worldwide use. The adapter comes with a set of exchangeable adapter
plugs that fit most common worldwide wall sockets.
1 Put the adapter in the wall socket.
2 Insert the appliance plug into socket on the appliance (Fig. 4).
, Only the outline of the charge indication is visible.
, As the battery charges, the four bars of the charge indication flash
one by one and fill as the charge increases.
, When the battery is fully charged, the charge indication stops
flashing.
Note: Charge the goLITE BLU energy light at least 8 hours before you use it
for the first time. Charging normally takes 3 to 4 hours.
Note: When the battery is fully charged, it contains enough energy for 3 to 5
treatments.
installation
1 Remove the stand from the stand storage cavity (Fig. 5).
2 Insert the bevelled end of the stand into the hole on the back of
the appliance. Magnets hold the stand in place (Fig. 6).
EnglisH 14