Philips SHAVER Series 3000 afeitadora eléctrica en seco - Manual (Page 5)

Charging
Charge the appliance:
- before first use and when you have not used the appliance for a
long time
- when the motor stops or starts running slower
When you have charged the shaver for the first time and after a long
period of disuse, optimise the battery capacity in the following way:
1 Fully charge the shaver and then use it normally until the battery
is completely empty. Repeat this process two more times. If you
optimise the battery capacity in this way, you can also charge the
shaver in between shaves, even if the battery is not completely
empty yet.
Charging the shaver (HQ6996, HQ6990, HQ6986, HQ6976,
HQ6950, HQ6947, HQ6927, HQ6926, HQ6925, HQ6923 only)
Quick charge (HQ6996, HQ6990, HQ6986 only)
After the shaver has charged for 3 minutes, it contains enough energy for
one cordless shave.
1 Put the appliance plug in the shaver.
2 Put the mains plug in the wall socket.
Note: Make sure the shaver is switched off.
, The charging light goes on.
, HQ6996, HQ6990, HQ6986: Charge the shaver for at least 1 hour,
but not more than 24 hours.
When the battery is fully charged, the charging light starts flashing.
, HQ6976, HQ6950, HQ6947, HQ6927, HQ6926, HQ6925, HQ6923:
Charge the shaver for at least 8 hours, but not more than 24 hours.
Note: Do not leave the shaver connected to the mains continuously.
Note: You can also shave without charging. Simply connect the shaver to the
mains.
3 Remove the mains plug from the wall socket and pull the appliance
plug out of the shaver when the battery is fully charged.
ENGLISH 5