Buffalo G108 - Manual (Page 10)

3
UK
Making Coffee
1. Fill the water reservoir with cold water.
2. Place a filter paper inside the filter basket.
3. Measure the required amount of coffee into the filter paper and slide the filter basket into position.
4. Place the jug on the base hotplate beneath the filter basket.
5. Turn the Brewing power switch On . The Brewing Indicator lights up and hot water will begin to fill
the jug.
6. Once finished the Brewing indicator will switch off.
7. Leave the jug on the hotplate to keep warm, if required. Discard the coffee and filter paper from the
filter basket.
8. To turn Off the hotplate, turn off the Brewing power switch .
Using the Upper Hotplate
This appliance is fitted with a second hotplate to keep an additional jug warm. To use:
1. Place the jug on the upper hotplate.
2. Turn the Upper hotplate power switch On .
Cleaning, Care & Maintenance
• Always turn off and disconnect the appliance from the power supply before cleaning.
• Use soapy water and a damp cloth to clean the exterior of the appliance.
• Dry thoroughly after cleaning.
Note: Use the Jar to fill the reservoir to ensure it’s maximum capacity is not exceeded.
The maximum amount of water the reservoir can contain is 2.2 litres.
Note: During operation, steam may rise from the appliance and loud bubbling noises
may be heard. This is perfectly normal.
WARNING: The glass jug becomes hot during operation. Always pick up the jug by the
handle to avoid injury.
WARNING: The surrounding surface of the hotplate may become hot. DO NOT touch!
Never heat an empty Jug on the hotplate, or allow the Jug to run dry.