BenQ MP576 - Manual (Page 41)

Operation 41
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker(s).
Be sure you have made a correct connection to the projector audio input. See
"Connection" on page 18 for how the audio input is connected.
Muting the sound
To temporarily turn off the sound:
1.
Press Menu/Exit and then press / until the SYSTEM SETUP: Advanced menu
is highlighted.
2. Press to highlight Audio Settings and press Mode/Enter. The Audio Settings
page displays.
3. Highlight Mute and press / to select On.
Adjusting the sound level
To adjust the sound level, press Volume +/- on the
remote control, or:
1.
Repeat steps 1-2 above.
2. Press to highlight Volume and press / to
select a desired sound level.
Turning off the Power On/Off Ring Tone
To turn off the ring tone:
1.
Repeat steps 1-2 above.
2. Press to highlight Power On/Off Ring Tone and press / to select Off.
The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound
mute or changing the sound level will not affect the Power On/Off Ring Tone.
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
• Menu Display Time in the SYSTEM SETUP: Basic > Menu Settings menu sets the
length of time the OSD will remain active after your last key press. The time length
ranges from 5 to 30 seconds in 5-second increments. Use
/ to select a suitable
time.
• Menu Position in the SYSTEM SETUP: Basic > Menu Settings menu sets the OSD
position in five locations. Use / to select a preferred position.
• Language in the SYSTEM SETUP: Basic menu sets your familiar language for the
On-Screen Display (OSD) Menus. Use / to select your language.
• Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be
displayed during projector start-up. Use / to select a screen.