Philips HAIRCLIPPER Series 1000 Cortapelos - Manual (Page 9)

- The hair length after cutting is only visible when one of the combs is
attached. Use the small comb for a hair length of 3-21mm and use
the large comb for a hair length of 23-41mm.
1 Slide the comb into the guiding grooves of the appliance
(‘click’) (Fig. 5).
Make sure that the arms of the comb have been properly slid into the
grooves on both sides.
2 Turn the length lock to set the comb to the desired hair length
setting (Fig. 6).
- The small comb cuts the hair to a length of 3mm, 6mm, 9mm, 12mm,
15mm, 18mm or 21mm.
- The large comb cuts the hair to a length of 24mm, 27mm, 30mm,
33mm, 36mm, 39mm or 42mm.
3 Switch on the appliance (Fig. 7).
tips
- We advise you to start clipping at the highest setting of the large
comb and to reduce the hair length in small steps until you reach the
desired hair length.
- If a lot of hair has accumulated in the comb, remove the comb and
blow and/or shake the hair out of it. Removing the comb does not
change the selected hair length setting.
- Write down the hair length settings used to create a certain hairstyle
as a reminder for future clipping sessions.
Clipping without comb
You can use the clipper without comb to contour the neckline and the
area around the ears.
The comb keeps the cutting unit at a certain distance from your head.
This means that, if you use the clipper without the comb, your hair will be
cut off very close to the skin.
1 Pull the comb off the appliance (Fig. 8).
Never pull at the flexible top of the comb. Always pull at the bottom
part.
English 9