beautypg.com

Beko WM 6123 S User Manual

Page 32

background image

32

EN

There is too

much foam.

You may not be using

proper detergent for

automatic washing

machines.

Use only automatic washing machine detergents in

your washing machine.

Excessive amount of

detergent may have been

used.

Use only sufficient amount of detergent.

Too much detergent may

have been used for a small

amount of lightly soiled

laundry.

Use only sufficient amount of detergent.

Detergent may have been

stored improperly.

Store detergent in a closed and dry location. Do

not store in excessively hot places.

Type of material being

washed (lace items will

cause excessive foam due

to their meshed structure).

Use smaller amounts of detergent for lace items.

Detergent might have

been put in the wrong

compartment.

If you put detergent in the prewash compartment

although you have not selected a prewash cycle,

the machine can take this detergent during rinsing

or softener step.

Softener being released

early.

You may have added too much softener.

The detergent dispenser might be problematic.

Water may be siphoned (pulling the softener into

the washer early) during the fill or rinse cycles.

There might be problems with the valves.

Machine does

work. No light

is on.

The plug might not be

plugged in the mains outlet. Plug should be checked.
Fuse may have blown.

Fuse should be checked.

Electricity may be cut off.

Power should be checked.

The “On/Off” button might

have not been pressed.

This button must be pressed.

The machine

did not start

after the

program was

selected and

the ‘Start/

Pause/Cancel’

button was

pressed.

The front door may be ajar.

“Washing”

and “Start/

Pause/Cancel”

lights are

flashing after

the program is

started.

Water may have been cut

off.

You can restart your machine by pressing the

“Start/Pause/Cancel” button for a short time after

ensuring that the water is not cut off.

The “Lid” light

is flashing.

It shows the safety period

until the door lock is

opened.

For your safety, the front door can only be opened

2 minutes after the program is completed. The

“Lid” light will flash during this period.

This manual is related to the following products: