Philips Satinelle Depiladora User Manual

Page 3

Cleaning the epilating head

Push the epilating head in the direction of the

arrows on the back of the appliance (1) and remove

it (2) (Fig. 15).

Remove loose hairs with the cleaning

brush (Fig. 16).

Rinse the epilating head under the tap for 5-10

seconds while turning it (Fig. 17).

Shake the epilating head firmly (Fig. 18).

Dry the epilating head thoroughly with a tea towel.

Note: Make sure the epilating head is completely dry before

you place it back onto the appliance.

Replacement

All parts of the appliance can be replaced. If you need to

replace one or more of the following parts, go to your

Philips dealer or an authorised Philips service centre:

appliance itself

epilating head

sensitive area cap

opti-start cap with massage element

hair-lifting attachment with massage element

cleaning brush

adapter
Environment
Do not throw away the appliance with the normal

household waste at the end of its life, but hand it in

at an official collection point for recycling. By doing

this, you help to preserve the environment (Fig. 19).
Guarantee & service

If you need service or information or if you have

a problem, please visit the Philips website at

www.philips.com or contact the Philips Consumer Care

Centre in your country (you find its phone number in

the worldwide guarantee leaflet). If there is no Consumer

Care Centre in your country, go to your local Philips

dealer.

Troubleshooting

This chapter summarises the most common problems

you could encounter with the appliance. If you are unable

to solve the problem with the information below, contact

the Consumer Care Centre in your country.

Problem

Cause

Solution

Poor epilating

results.

You move the

appliance in the

wrong direction.

Move the appliance

against the direction of

hair growth, with the

on/off slide pointing in

the direction in which

you move the appliance.

You place the

epilating head on

the skin at the

wrong angle.

Make sure that you

place the appliance on

the skin at an angle of

90° (see chapter ‘Using

the appliance’).

You used a

(depilatory)

cream prior to

epilation.

Make sure your skin

is clean, entirely dry

and free from grease.

Do not use any cream

before you start

epilating.

The hairs are too

short.

Sometimes hairs are too

short to be caught. The

optimal length for easy

removal of the hairs is

3-4mm. The hairs that

are not caught during

this session will be long

enough to be removed

when you epilate the

next time. You can also

try to catch the hairs by

moving the appliance

across the skin a few

more times.

Problem

Cause

Solution

The

sensitive area

cap is on the

epilating head

when you epilate

your legs.

Do not use the sensitive

area cap when you

epilate your legs, as the

cap reduces the number

of active epilating

discs. NB: Never use

the epilator without

the sensitive area cap

when you epilate your

underarms or bikini line.

The appliance

does not work.

The socket

to which the

appliance is

connected is

not live.

Make sure the socket

is live. If you have

connected the epilator

to the socket in a

bathroom cabinet, you

may need to switch on

the bathroom light to

activate the socket.

I cannot

remove the

epilating head

from the

appliance.

You try to pull it

straight off.

Push the epilating

head in the direction

of the arrows on the

back of the appliance

before you pull it off

the appliance (see

chapter ‘Cleaning and

maintenance’).

4203.000.4314.1

3/9