Philips BEARDTRIMMER Series 9000 barbero resistente al agua - Manual (Page 13)

cleaning the appliance and the combs
1 Switch off the appliance.
2 Pull the comb off the trimming head.
3 Clean the trimming head under the tap with lukewarm water or
clean it with the cleaning brush supplied.
4 Clean the trimming combs under the tap or clean them with the
cleaning brush supplied.
Tip: To make sure that the appliance is dry before you store it in the pouch,
let it dry in a well-ventilated room with the laser popped up.
cleaning the trimming head connector
Note: Make sure you clean the trimming head connector at least once every
three months.
1 Switch off the appliance.
2 Pull the comb off the trimming head.
3 Pull the trimming head off the appliance.
Note: To prevent damage to the laser guide, put the laser guide in ‘off’ position
before you remove the trimming head.
English 13