Blaupunkt GRENOBLE RD 169 - Manual (Page 19)

39
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Deactivating the hour correction
function
In the DSC menu it is possible to switch off
the hour correction function with “CLK MAN/
CLK AUTO”. An automatic correction for mi-
nutes will continue to take place.
This is useful if you would like to display the
time for a different time zone, for example.
If necessary,
•
Press “DSC” briefly and / as often as
required until “CLK MAN/CLK AUTO” ap-
pears in the display.
•
To deactivate the hour correction
function press <> to select “CLK MAN”.
•
Press <> to set the hours/minutes.
DSC programming
The car radio has been equipped with DSC
(Direct Software Control) to allow you to cu-
stomise certain programmable, basic set-
tings to suit your personal needs and prefe-
rences and then store them.
The basic settings for this audio equipment
were made at the factory.
In the following you can find an overview of
these settings, so that you can always reset
to them if desired.
If you wish to alter any of the programming,
•
press “DSC”.
Use the rocker switch to select and set the
functions you wish to change. The display
will show you the setting you have selec-
ted.
Press / to select the function.
Press << />> on the rocker switch to chan-
ge or recall the values.
Note:
Whether the settings listed in the following
are available or not depends on the car au-
dio system model and the features with
which it is equipped.
If you cannot select any of the functions li-
sted here, then your car audio system is not
equipped with that feature and it cannot be
adjusted as a result (also see the section
on “Equipment features list”).
AM ON/OFF It is possible to block out
one or both of the AM wave-
bands (MW/LW).
This means you will select
only the wavebands you
want when you press “BA/
TS”:
AM ON - all wavebands are
available
MW OFF - LW, FM only
LW OFF - MW, FM only
AM OFF - FM only
BEEP Acknowledgement tone for
all functions which require a
button to be pressed for
more than one second.
The volume can be adjusted
from between 0 to 9. (0 =
off)
CLOCKSET Sets the clock manually.
Refer to the section on
“Clock”.
CLK. MAN. Switches off hour correction
function.
Read the information in the
section on “Clock “.
CLK. AUTO Automatic hour correction
using the RDS/CT signal.
Refer to the section on
“Clock”.
BA Grenoble RD169 gb 95%® 30.05.2002, 10:59 Uhr 39