Philips SalonCurl Pro Rizador - Manual (Page 9)

You can adjust the set temperature by pressing the + and - buttons.
Look at the display to see the temperature you have selected. The
light burns red as long as the appliance is heating up to the set
temperature (Fig. 3).
The light turns green as soon as the set temperature has been
reached (Fig. 4).
The bars on the display show the remaining usage time of the
appliance. The total usage time is 60 minutes. Every ten minutes one
of the six bars will disappear.
curling your hair
1 Divide your hair into locks and put them aside with clips. (Fig. 5)
The thinner the lock of hair, the tighter the curl will be.
Start at the lower part of your head and work your way up to the
crown.
Take the lock you want to curl and comb it first, to get rid of
tangles (Fig. 6).
Take the lock of hair, open the clip by pressing the lever and place
the lock between the barrel and the clip. (Fig. 7)
5 Release the lever and slide the barrel to the end of the lock (Fig. 8).
6 Take the cool tip between your fingertips and wind the hair around
the barrel until you have almost reached your scalp. Make sure the
end of the lock is wound in the required direction (Fig. 9).
7 Hold for 15 seconds.
8 Unwind the lock of hair until the clip can be opened again with the
lever (Fig. 10).
using the slide-on spiral
Only slide the spiral on or off the barrel when the appliance has
cooled down, to avoid burning your fingers.
With the spiral you can create ringlets by winding the lock round
the barrel following the spiral profile.
,
,
,
,
EnglisH 9