Philips AVENT Equipo de extracción doble - Manual (Page 20)

CONCERN SOLUTION
Cracking or
discolouration
of pump parts • Avoid contact with antibacterial or abrasive
detergents/cleaners as they can damage the plastic.
Combinations of detergents, cleaning products,
sterilising solution, softened water and temperature
fluctuations may, under certain circumstances,
cause the plastic to crack. If this occurs, do not use.
The pump bodies and breast milk containers are
dishwasher safe but food colourings may discolour
them. Follow guidelines in ‘How to clean and sterilise
your Twin Electronic Breast Pump’ of the instruction
booklet.
Lost or broken parts • Contact Philips AVENT Customer Services for
replacements (see back cover for contact details).
Pump not
responding • Ensure the pump is correctly assembled and
switched on with the power indicator
illuminated
GREEN .
• Make sure the cables between the electrical wall
socket and the pump are correctly connected.
Pump light
flashing
RED
If the pump stops working and the power light
is flashing
RED then a fault has been detected.
• 3 flashes, delay, 3 flashes, etc – the pump has
detected a vacuum fault. Switch off the pump
motor and check tubing and connections for
obstructions or damage.
• 2 flashes, delay, 2 flashes, etc – the pump has
detected that it has overheated. Switch off the
pump motor. Ensure unit is not exposed to heat
sources or sitting in direct sunlight. Allow unit to
stabilise before trying again.
• Continuous flashing – the pump has detected that
the control cable has been incorrectly fitted/not
fitted or the cable is damaged.
19