Philips AVENT Vigilabebés DECT - Manual (Page 5)

5
D Note:
Please note that the parent unit does not charge
the batteries when it is connected to the mains.
You can use rechargeable batteries in the parent
unit, but you need to charge them in a separate
charger.
B Warning:
Unplug the parent unit and make sure your
hands and the unit are dry when you insert the
batteries.
1
Press the release button (1) to unlock the
battery compartment lid and remove the lid
(2).
2
Insert the non-rechargeable batteries or fully
charged rechargeable batteries.
D Note:
Make sure the + and - poles of the batteries
point in the right direction.
4 Preparing for use
4.1 Baby unit
The baby unit is mains-operated and has a fixed
mains cord.
1
Put the adapter of the mains cord in a wall
socket to connect the baby unit to the mains.
4.2 Parent unit
The parent unit runs on mains power. You can also
insert batteries to allow mobile use of the parent
unit.
4.2.1 Mains operation
1
Put the small plug in the socket in the side
panel of the parent unit and put the adapter
in a wall socket.
4.2.2 Inserting the batteries
If the parent unit is not close to a wall socket,
you can run it on two 1.5V R6 AA alkaline
non-rechargeable batteries or two 1.2V R6
AA rechargeable batteries (not supplied). The
operating time on full batteries is up to 24 hours,
depending on the type of batteries used and on
how long and how often you use the parent unit
on batteries.
ENGLISH