Philips Wake-up Light - Manual (Page 10)

alarm demonstration
If you want to get a quick demonstration (60 seconds) of the gradually increasing light level and
sound level, activate the test function of the appliance.
1 Push the control lever down to the bottom position for a few seconds until TEST appears on
the display (Fig. 21).
2 Push the control lever down again to stop the demonstration.
Note: The appliance continues to run the alarm demonstration until you push down the control lever
again. The test automatically stops after 9 hours.
radio/volume
1 To switch on the radio, press the radio on/off button (Fig. 22).
2 To select the desired radio frequency, press the menu + and - button (Fig. 9).
Tip: To scan radio frequencies automatically, press and hold the menu + or - button for approx. 2 seconds.
Tip: To make sure you get a good radio signal, fully unwind the antenna and move it around until you
have found a position at which reception is best.
3 To switch off the radio, press the radio on/off button again.
volume
1 To set the volume, press the volume increase or decrease button (Fig. 23).
You can choose a volume level between 1 and 20.
Note: The volume level you have selected is automatically set as the volume level for the alarm as well.
sunset simulation
You can use the sunset simulation function if you want the light and/or the sound of the Wake-up
Light to stay on and dim gradually during a set period of time (15 minutes to 1.5 hours) before you
go to sleep. The lamp and/or sound switch off automatically after the set time.
1 Switch on the lamp and/or the radio. See sections ‘Using the lamp’ and/or ‘Radio/volume’ in
this chapter.
Note: If neither the lamp nor the radio is on when you activate the sunset simulation function, then only
the lamp goes on.
2 Follow steps 1 to 5 in section ‘Menu function’ in this chapter to select the sunset simulation
function and to set the sunset simulation time (Fig. 24).
You can choose a time from 15 to 90 minutes (15 minutes, 30 minutes, 45 minutes, 1 hour or 1.5
hours).
, After the set time, no matter whether only the light and/or the radio are on, the sunset
simulation function switches off both light and sound.
Tip: you can also press the lamp on/off button for more than 3 seconds to activate the sunset simulation
function.
setting the display brightness
1 Follow steps 1 to 5 in section ‘Menu function’ in this chapter to select the display brightness
function and to increase or decrease the display brightness (Fig. 25).
You can choose a display brightness between 1 and 4.
EnglisH 10
4222_002_7572_2_DFU-Booklet_A5_v1.indd 10 11/29/2012 10:45:19 AM